How to use the print head correctly in the stylus printer

2020-05-28

Font size:

1.Causes of needle leakage and needle breakage in print head

1. Print head

Ribbon oil and dust are adhered to the printing pins and guide pin plates.

2. Ribbon and its drive components

The quality of the ribbon core is poor, which is mainly manifested in that the joints of the ribbon are not smooth. After printing for a period of time, wrinkles or pores cause the ribbon to be scraped and the needle is broken. The ribbon drive assembly can not retract the ribbon in time when the print head is broken.

3. Ribbon Spacer

Sometimes, because the ribbon spacer is not installed in place, the printing needle is hit on the ribbon spacer, causing needle leakage.

4. Printing paper

Use printing paper with scar dots;

Print the envelope on the connector;

Use wax paper that is softer than normal printing paper;

5. Clearance between print head and glue stick

The use of different thickness of the printing paper did not adjust the gap

6. Printing glue stick

The printing glue stick is worn and not replaced in time, or other glue sticks with different hardness and poor coaxiality are replaced.

7. Drive circuit and anti-peak circuit

Due to the open circuit and short circuit of the drive tube; Eliminate the leakage caused by the short circuit of the voltage stabilizing diode of the three-stage tube.

 

2.Ways to Avoid Needle Leakage and Broken Needle

1. Timely cleaning the print head

After using for a long time, the method of removing the print head, placing its front end in anhydrous alcohol bubble for half an hour, and then cleaning it.

2. Buy good ribbon and replace it in time

When purchasing a core, you should choose a core with a fine, smooth joint. Long time print wrinkles or pores should be replaced in time.

3、Adjust the gap between the print head and the glue stick

The paper type shall correspond to the position of the adjusting lever.

4、Replace the printing stick in time when it is worn.

Note: Do not pull the paper when printing, and do not print more than the printing paper.